![]() Once the client starts DOSBox, you should see this on the server status window: Serial1: Nullmodem server waiting for connection on port 23. You should see status on the server computer like this in the "DOSBox Status Window" Now save the configurations files and start up dosbox on the client and server computers. ![]() Then for the client configuration, do the same thing except add "server:x.x.x.x" (where x.x.x.x is the servers IP address) # transparent, port, inhsocket (all optional). # for nullmodem: server, rxdelay, txdelay, telnet, usedtr, # for directserial: realport (required), rxdelay (optional). # Additional parameters must be in the same line in the form of # Can be disabled, dummy, modem, nullmodem, directserial. # serial1-4 - set type of device connected to com port. Open this file using notepad (or your program of choice) and scroll down until you see the section called įor the server computer you just need to select one of the serial ports (i used serial1 below) and set it to nullmodem ![]() In the dosbox folder (defaults to c:\program files\dosbox-0.72) there is a configuration file called nf The computer IP addresses in this example are listed below: ![]() These instructions for configuring Dosbox ( ) to allow Command HQ to be played by two players over the Internet are courtesy of Ryan Walz: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
September 2023
Categories |